1. Plug the power cord into an active outlet.

2. Press the Power Trigger once to turn the Vacuum ON (trigger does not need to be held).

3. Press the Power Trigger once to Turn OFF the Vacuum.

1. Turn Vacuum OFF, then unplug vacuum.

2. To remove dirt from the dustbin canister and filter, hold the vacuum vertically. Press the Dustbin Canister Release, rotate the canister and pull down to release.

3. Remove the HEPA Filter and screen filter housing.

4. Empty dustbin canister contents into trash. The HEPA filter can be tapped gently to dislodge fine dust and then rinsed under cold water. Allow to FULLY dry before re assembling.

5. Replace the filter housing into the top of the dustbin canister and push down to secure. Drop the dry HEPA filter into the center of the assembly.

6. Attach dustbin canister onto vacuum by rotating until you hear a "click".

NOTE: View manual for illustrations.

WARNING - Turn vacuum OFF and unplug from outlet before performing maintenance.

1. Remove the floor brush from the tube by pressing the release button and pull apart.

2. Turn the floor brush over and locate the brush roll release switch Slide the release switch while simultaneously pulling up on the latch.

3. Lift out the roller brush by pulling up on the tab. Remove debris / hair wrapped around the roller.

4. Reinstall the roller. Wipe down the inside of the housing and ensure there is no debris lodged in the neck of the brush or metal tube.

5. Reinstall the roller latch to secure the roller in place.

NOTE: View manual for illustrations.

1. Dustbin Canister may be full. Empty in trash.

2. Filter is clogged or wet. Remove filter and rinse under water. Allow to dry for 24 hours BEFORE reassembly.

3. Check roller brush and/or tube for obstructions and remove debris.

The filters are not properly secured. Please see filter maintenance FAQ or view manual for illustration on how to properly install the filters.